The XY-CD60 is a versatile battery charge and discharge controller module designed for DC 6V–60V systems, including lithium and lead-acid batteries. It functions primarily as a voltage-triggered switch to prevent overcharging or deep discharging. Manuals & Documentation
XY-CD60 Solar Battery Charge Controller Module - RoboFactory
. It acts as a voltage-controlled switch (relay) that protects batteries from overcharging and over-discharging. 1. Key Specifications Voltage Range: DC 6V to 60V. Control Mode: Charging Mode (IN) and Discharging Mode (OUT). HD LCD showing voltage, percentage, and time. Relay Action: Only acts as a switch; it change the voltage or limit current. 2. Mode Selection To switch between Charging and Discharging modes: Long-press the button for about 5 seconds. The screen will display for Charging Mode or for Discharging Mode. 3. Parameter Settings
- Connection refused: Check that the device is properly configured and powered on. Verify that the connection parameters are correct.
- Data transfer errors: Check that the connection is stable and that data is being transferred accurately. Adjust the connection parameters if necessary.
- Device not recognized: Check that the device is properly configured and that the Xycd60 device is set to the correct mode.
Real-Time Monitoring: Features an LCD that displays battery voltage and charge percentage (calculated as
Troubleshooting: If the XYCD60 Manual Link is Broken
Sometimes the original link disappears. Here is your recovery plan:
For detailed wiring diagrams and step-by-step programming, you can access the following manuals:
For a detailed visual walkthrough of the wiring and advanced timer settings, you can refer to community resources like Robojax or technical guides on ICStation.
Set Limits: Short-press SET to cycle through parameters like UP (upper limit) and dn (lower limit), then use the UP/DOWN buttons to adjust values.