Xnx Universal Transmitter Quick Start Guide -

Xnx Universal Transmitter Quick Start Guide

Safety & Prep

Do not expose to water or extreme heat.
Use only the provided power accessory or specified alternatives in the full manual.
Keep antenna clear of obstructions for best range.
Charge fully before first use (indicator: solid LED).

CLI Cheat Sheet (examples)

Show status:
```
status
```

Set LoRa, 915 MHz:

radio set mode lora
radio set freq 915000000

Sampling interval to 5 minutes:
```
sample set interval 300
```
Force test send:
```
send test
```

Its "universal" nature means it uses a common interface for all sensor types, simplifying maintenance and training across your facility. 2. Mounting and Installation Xnx Universal Transmitter Quick Start Guide

3. Wiring the Xnx for Power and Signal

The Xnx Universal Transmitter supports 24 VDC (nominal, 18-30 VDC) and can be configured for 3-wire (power, ground, signal) or 2-wire (loop-powered) operation. This guide covers the common 3-wire 4-20mA setup. Xnx Universal Transmitter Quick Start Guide Safety & Prep

The Xnx Universal Transmitter is a highly versatile and widely used device in various industries. By following this Xnx Universal Transmitter Quick Start Guide, you'll be able to install, configure, and operate your device with confidence. Remember to consult the user manual and manufacturer's support for more detailed information and troubleshooting guidance. Do not expose to water or extreme heat

By following this comprehensive guide, users can ensure safe and effective operation of the XNX universal transmitter, providing reliable gas detection and enhancing overall safety and process control.

Wall Mounting: Use the provided mounting hardware to secure the transmitter to a wall or a flat surface. Ensure the device is level and securely fastened.
Panel Mounting: Mount the transmitter in a panel cutout using the provided panel-mounting kit. Ensure the device is securely fastened and accessible for maintenance.
Pipe Mounting: Use a pipe-mounting bracket to secure the transmitter to a pipe or tubing. Ensure the device is securely fastened and accessible for maintenance.

Step 1: Install the sensor module. Open the lower sensor compartment (separate from the main wiring area). Align the sensor’s 3-pin or 5-pin connector with the socket. Press firmly until it clicks. Do not force rotation—polarization keys prevent wrong insertion.