Wella Climazon Millenium Manual Install May 2026

Wella Climazon Millennium (often referenced interchangeably with its successor, the Climazon 2

  1. Filter cleaning: Weekly – vacuum the rear grille. Monthly – wash the foam inner filter (if equipped) with mild soap and air dry completely.
  2. Hinge lubrication: Every 6 months – apply a drop of silicone spray (not WD-40) to the articulation joints.
  3. Terminal inspection: Annually – with power off, remove the bracket cover and re-torque the L/N/E screws. Loose terminals cause arcing/fire.
  4. Cord strain relief: Check that the cord isn't pinched between the arm and the wall.

Final Safety Reminder: Never leave the Climazon Millenium running unattended, especially in steam mode. Ensure the water reservoir never runs dry, and always position the unit away from water basins to prevent electrical shock. wella climazon millenium manual install

The mobile unit is mounted on a height-adjustable stand with rollers (typically the ST5 tripod). Filter cleaning: Weekly – vacuum the rear grille

Wall-Mounted Version: Typically utilizes the Acrobat 2004 wall arm (models WA04/75 or WA04/95). This arm consists of a boom and a spring arm for flexible positioning. Key Installation Components Final Safety Reminder: Never leave the Climazon Millenium

Purpose

To guide technicians or salon owners through a tool-based, manual installation of the Wella Climazon Millenium hood dryer when the original wall/ceiling bracket is missing, damaged, or when using a third-party stand.

Locking Mechanism: The device often features an internal locking latch. Ensure the head is pushed down until it "clicks." You can verify the lock by attempting to lift it gently without using the release mechanism.

  1. “Do you have the original mounting bracket?” → No
  2. “Print template A4 (hole spacing 142mm x 68mm).”
  3. “Drill pilot holes – use 8mm concrete bit if ceiling is solid.”
  4. “Attach bracket. Place phone on bracket – tilt now: 0.3° – acceptable.”
  5. “Connect wires: Brown to L1, Blue to N, Green/Yellow to Earth.”
  6. “Test swing arm: Hood drops? Turn clutch nut ½ turn clockwise.”
  7. “✅ Installation stable. Run noise test… No abnormal vibration.”

2. Manual Torque & Leveling Guide

  • Step-by-step instructions with visual torque references (e.g., “tighten M8 bolts until washer compresses 1mm”).
  • Built-in digital bubble level (using phone gyroscope) to align the mounting plate within 0.5° tilt.
  • Warns if tilt exceeds recommended 2° to prevent hood swing issues.