Cat4500e-universalk9.spa.03.11.04.e.152-7.e4.bin 〈Trusted Source〉

Title: Experience with cat4500e-universalk9.spa.03.11.04.e.152-7.e4.bin (IOS 15.2(7)E4)

Since "make an feature" is a broad request, here is how you can enable a common feature, such as Port Security, using this software version: Feature Highlight: Configuring Port Security cat4500e-universalk9.spa.03.11.04.e.152-7.e4.bin

• cat4500e — Catalyst 4500E series
• universalk9 — feature/license bundle (broad feature set including advanced routing, MPLS, VPNs, security features)
• spa — SPA/SP-architecture build of IOS XE
• 03.11.04 — major/minor IOS XE train version
• e.152-7.e4 — internal build/maintenance identifiers

Q5: My switch has IP Base license – will this image work?
Yes, but you need a valid license for higher features. The image will run in evaluation mode temporarily. Title: Experience with cat4500e-universalk9

Enter IP address, filename cat4500e-universalk9.spa.03.11.04.e.152-7.e4.bin, and confirm. Q5: My switch has IP Base license – will this image work

5. 152-7.e4

• Image version string (often seen in show version) – Mapped to 15.2(7)E4.
• Wait, there's a discrepancy? Actually, sometimes the filename version is older than the internal version. In this case:
  03.11.04.e = 15.2(4)E, but 152-7.e4 suggests 15.2(7)E4.
  This is likely a transitional build or a labeling artifact. Always trust show version output after booting the image.

The image is typically loaded via TFTP or USB to the switch's bootflash. Ensure you verify the MD5/SHA checksum provided by the Cisco Software Download portal before installation. JustAnswer Are you planning to a current switch to this version, or are you troubleshooting an existing OSPF or CPU issue on this specific firmware?

A comparison between this version and the newer 3.11.10E release Checking the compatibility for a specific line card model