Bystronic Laser Error Code List ^hot^ Online

Bystronic laser systems use a variety of error and alarm codes to indicate mechanical, electronic, or software issues. While the specific list of codes can vary based on your machine's controller (such as the or the newer

• Cause: There is an issue with the control system software.
• Solution: Restart the control system. If the error persists, contact technical support.

10) Error: Calibration / Focus Error

• Meaning: Automatic focus or calibration routine failed or gave readings outside limits.
• Immediate checks:

  Step 2: Access the Error Log

  Navigate to: Service → Diagnostics → Error History This shows the last 100 errors with timestamps. Identify if the error is persistent or intermittent. bystronic laser error code list

  Record the Exact Code: Note the number and the accompanying text. Bystronic laser systems use a variety of error

  Which of those would you like?

  1. Record: note code, timestamp, active program, material.
  2. Safe stop: pause program and secure machine per procedure.
  3. Visual & status check: read control panel, inspect visible systems (gas, coolant, optics).
  4. Quick remediation: clear obstructions, restore consumables, reset interlocks.
  5. Test: run a short diagnostics cycle or a low-power test cut.
  6. Escalate: if unresolved, log findings and contact certified Bystronic service.

  | Code / ID | Description | Probable Cause & Solution | | :--- | :--- | :--- | | H200 | Focus Position Error | The Z-axis cannot find the focal point. The focusing lens may be loose, or the capacitance sensing is failing. Clean the lens and check the Z-axis drive. | | H210 | No Signal from Head | Communication lost between the cutting head sensor and the CNC. Check the fiber optic cable (for sensor data) or the serial connection. | | H300 | Crash / Collision | The cutting head hit the material or the slats. Check for tip damage. Recalibrate the head. | | H405 | Capacitive Sensor Drift | The height control system is drifting. Perform a "Sensor Calibration" or "Zero Set" on the head. | | Lens Temp High | Overheating Optics | Cooling water flow to the cutting head is restricted, or the lens is Cause: There is an issue with the control system software